Fine Handmade Jewelry-An Inspired Bracelet out of Wire

In this tutorial for fine handmade jewelry, you may find that sometimes it’s a little tricky to work with wire. But it’s not such a bad thing when working on your new accessory. Instead of making use of irritating beads and charms, you can start the bracelet simply with inches of soft and versatile jewelry wire. You are going to love it!

Supplies needed:

2mm Aluminum Wire

4mm Acrylic Bead

Headpin

Round Nose Plier

Side Cutting Plier

Necessary process of the fine handmade jewelry:

Step 1: work the basic figure “8” component

1. Take you wire coils. Reserve 2.5cm at beginning and form a loop around round nose pliers with leftover wire;

2. Work another loop in the contrary direction. This will be a complete “8” pattern.

3. Keep 2.5cm at the end and then remove the excess wire.

4. Curve the ends inwards to create a small hook.

5. For a common size wrist, 12 pieces may be enough.

Step 2: connect the above components

Place the “8” on a flat surface and connect each two pieces as the picture shows. Keep repeating the process until you get a close circle.

Step 3: prepare the decorative bead danglers

Slide one acrylic bead onto a headpin and form a simple loop on top. Generally, 12 pieces are ok.

On each figure “8” component, attach one beaded dangle.

You have finished this ingenious fine handmade jewelry. The entire bracelet is composed of one same component, so the only thing you need to do is repeat the same steps over and over and then assemble the parts to complete the piece. Try making and wearing it, and this season you can be wrist-deep in trendsetting style.