PandaHall Original DIY Project – How to Make a Wire Wrapped Gemstone Bangle Bracelet

To make this gemstone bangle bracelet, you just need to prepare a druzy agate gemstone pendant and 2 different sized jewelry wires, then you can easily make them to a bangle bracelet with your pliers.

Supplies needed to make the gemstone bangle bracelet:

Druzy Agate Pendant
3mm Wide Aluminum Wire
1mm Copper Wire
Round Nose Pliers
Long Nose Pliers
Side Cutting Pliers

How to make the wire wrapped bangle bracelet:

Step 1: Wrap the agate pendant with copper wire

1st, cut about 20cm copper wire, wrap a loop at one end of the wire;
2nd, wrap the wire around the agate pendant like the picture shows.

Step 2: Make one side of the wire wrapped bangle bracelet

1st, cut about 15cm (here the length depends on the size of your wrist) of 3mm aluminum wire, make a loop at one end of the wire;
2nd, thread the copper wire through the aluminum wire loop, and twist the copper wire around the aluminum wire like the picture shows.

Step 3: Make the other side of the wire wrapped bangle bracelet

1st, cut another piece of 20cm copper wire and wrap it to the agate pendant like we’ve done in step 1;
2nd, cut another piece of 15cm aluminum wire, make a loop at one end and wrap the copper wire around the aluminum wire like we’ve done in step 2.

Step 4: Complete the wire wrapped bangle bracelet

1st, make a loop at each of the aluminum wire ends, twist the copper wires to the loops to fix them;
2nd, bend the wires into a bangle.

Here is the finished gemstone bangle bracelet:

It will be like this when you’re wearing it:

If you don’t like dark color gemstones, you can use a light color or bright color one to make this bracelet, just as you can see from this tutorial, it’s quite easy to make. So, don’t hesitate, just give it a try!