- Comments (0)
- Aug 29, 2016
How to Make Wire Wrapped Spider Pendant Necklace with Glass and Pearl Beads
Summary: Do you have spider jewelry? If not, you can see today’s Pandahall tutorial on how to make wire wrapped spider pendant necklace with glass and pearl beads. Hope you will like it.
Have you ever seen beaded spider necklace? How about wire wrapped spider jewelry design? You should never miss this tutorial on how to make wire wrapped spider pendant necklace with glass and pearl beads if you are interested in spider necklace design. Let’s see the steps one by one.
Supplies needed for wire wrapped spider pendant necklace:
11x8mm Green Drop Faceted Glass Beads
6mm Ivory Glass Pearl Beads Strands
8mm White Glass Round Beads Strand
0.5mm Gold Copper Jewelry Wire
0.8mm Gold Copper Jewelry Wire
Golden Brass Spring Clasps
Golden Brass Jump Rings
Golden Iron Twisted Chains Curb Chains
Golden Brass Headpins
Glue Gun
Flat Nose Pliers
Side Cutting Pliers
Round Nose Pliers
Instruction on how to make wire wrapped spider pendant necklace:
Step 1: Make the first part of the spider pendant necklace
1st, cut off four pieces of 0.8mm copper jewelry wire and put them on the table with crossing them;
2nd, cut of a long piece of 0.5mm jewelry wire wrap it around the cross wire pattern for many circles;
3rd, continue to wrap the wire until you get below pattern then tighten the wire and cut off the extra wire.
Step 2: Make the second part of the spider necklace
1st, trim off the under four pieces of jewelry wire and attach one of them onto the top of the pattern (as shown in the picture);
2nd, cut off two long pieces of 0.8mm copper wire and connect the top four pieces of wire;
3rd, make a loop respectively at the end of the four pieces of wire which are trimmed of.
Step 3: Make the third part of the spider necklace
1st, attach the wire and the loop respectively;
2nd, pinch the three pieces of wire together on the top and make a simple loop then.
Step 4: Make the fourth part of the spider necklace
1st, cut off a piece of twisted chain and connect it with the wire pattern at the top with two jump rings;
2nd, cut off five pieces of 0.5mm copper wire and wrap one piece of wire around the center part of the four pieces of wire pattern, then twist them into a spider shape.
Step 5: Make the fifth part of the spider necklace
1st, tighten the top end and the bottom end with copper jewelry wire;
2nd, slide a 11x8mm green faceted drop glass bead and a 6mm glass pearl bead onto a gold headpin.
Step 6: Make the sixth part of the spider necklace
1st, add the glass and pearl dangle onto the center of the wire spider pattern;
2nd, attach them tightly and connect the net wire and spider wire pattern with a jump ring and the headpin.
Step 7: Finish the spider necklace
1st, add an 8mm round glass bead onto the center of the net wire pattern with jewelry wire;
2nd, add a jump ring and a spring clasp onto the ends of the chain.
Here is the final look of this wire wrapped spider pendant necklace:
Another picture:
See, this cool wire wrapped spider pendant necklace with glass and pearl beads has been finished! How do you think of this cute design? If you are looking for any interesting and creative jewelry pattern, then this spider beaded necklace is suitable for you. Enjoy yourself!