Instructions on Making a Waxed Cord Necklace with Black Beaded Flower and Hot Pink Rhinestone Drop

Are you planning to make some jewelry for Mother's Day? Today I want to share with you a charming waxed cord necklace with black beaded flower and hot pink rhinestone drop. The main process is to bead the glass flower patterns, and i believe you will figure this out easily with my instructions below.

Supplies in making the waxed cord necklace with black beaded flower and hot pink rhinestone drop:

8mm White Glass Pearl Beads
Hot Pink Faceted Leaf Acrylic Rhinestone Beads
8mm Black Glass Faceted Beads
6mm Black Glass Rhinestone Montee Beads
Iron Twisted Chains
0.3mm Copper Wire
Black Waxed Cord
Iron Jump Rings
Iron Lobster Clasp
Cord Ending Clasp
Long Nose Plier
Glue Gun
Scissors
Lighter

Instructions on making the waxed cord necklace with black beaded flower and big hot pink rhinestone drop:

Step 1: Making the necklace cord

1st, cut 6 pieces of waxed cord of equal length (about 20cm), and divide them into 2 sets;
2nd, trim the ends of each set with lighter and press them;
3rd, attach an ending clasp to each end of the cords with hot glue.

Step 2: Add iron twisted chain

1st, prepare 4 jump rings, a lobster clasp and 2 pieces of twisted chains (one about 15cm and the other one about 3cm);
2nd, attach a jump ring to each ending clasp respectively;
3rd, connect the longer twisted chain to the black wax cord with jump rings;
4th, attach the small piece of twisted chain to a jump ring, then connect the ends of the waxed cord with a lobster clasp.

Step 3: Add acrylic rhinestone leaf drop ornament

1st, prepare 5 hot pink rhinestone leaf drop beads and 5 jump rings;
2nd, attach each jump ring to the hot pink leaf drop bead one by one;
3rd, cut 5 pieces of copper wire, then thread a 8mm white glass pearl beads through the wire respectively;
4th, tie the pearl bead to the jump ring with the copper wire one by one;
5th, attach the hot pink rhinestone leaf drop bead to the proper position of the twisted chain respectively.

Step 4: Make glass beaded flowers

1st, cut a piece of copper wire, slide 5 black glass beads on it, then cross the ends through a black glass bead and tighten;
2nd, thread the ends of the wire through 2 holes of a glass rhinestone montee bead respectively;
3rd, continue to thread the wires through the other 2 holes respectively and tighten up.

Step 5: Finish the whole beaded statement necklace

1st, repeat the procedures in step 4 and make 5 more glass beaded flowers;
2nd, tie the black beaded flower ornaments to the chain with copper wire one by one and finally trim off the excessive wires.

Here is the final look of this waxed cord necklace with black beaded flower and big hot pink leaf drop!

It would take you some time to make this charming waxed cord necklace with glass beaded flower and hot pink rhinestone drop, but it is really worthwhile to make such a gift for your dear mother, right? No more wait, have a try!