How to Make Personalized Wire Wrapped Rhinestone Rings with Gold Chain Linked

Just with gold chains, gold aluminum wires, pearls and rhinestones, you could also have a try to DIY this elegant personalized wire wrapped rhinestone rings with gold chain linked! You will find that it is really easy to make this ring design after reading the detailed steps below.

Supplies in making wire wrapped rhinestone ring with gold chain linked:

6mm White Pearl Beads
12x18mm Crystal Rhinestone Drop Beads
14mm Blue Rhinestone Round Beads
14mm Gold Rhinestone Round Beads
Gold Brass Ring Base
Gold Brass Jump Rings
Gold Cross Chain
2mm Gold Aluminum Wire
0.3mm Silver Copper Wire
Glue Gun
Long Nose Plier
Round Nose Plier
Side Cutting Plier

Instruction on making the gold chain linked crystal and blue rhinestone ring:

Step 1: Link 2 gold ring bases with gold chains

1st, prepare a piece of gold cross chain (about 20cm), 2 gold jump rings and 2 gold ring bases;
2nd, link the ends of the gold chain to the ring base with jump rings respectively.

Step 2: Make the blue rhinestone flower ring

1st, snip off a short piece of copper wire, thread it through 7 6mm white pearl beads to form a small circle (make the petals);
2nd, stick the petals to the ring base with hot glue;
3rd, stick a 14mm blue rhinestone round bead to the center of the petals and let it dry.

Step 3: Make another rhinestone ring

1st, snip off a piece of gold aluminum wire, and twist it as the picture shows;
2nd, stick 3 crystal rhinestone drop beads and a gold rhinestone round bead to the surface of the aluminum wire respectively;
3rd, stick the whole rhinestone ornament design to the other ring base with hot glue and let it dry.

I just love my gold chain linked crystal and blue rings on my fingers!

This rhinestone ring with gold chain linked gives an elegant aura. Besides, this gold chain linked ring goes well with all seasons! Do not hesitate; try this one with your own design!!