How to Make a Pink Ribbon Flower Brooch for Girls

If you have colorful ribbons available, then this DIY project on making a ribbon flower brooch with pearl bud and green leaves would be a great choice for you to give a try! The white pearl bead and silver bead cap add elegant element to the flower, while the green leaves make the flower alive. Please find my tutorial below if you want to try.

Supplies in making the pink ribbon flower brooch:

8mm White Pearl Beads
White Felt Paper
2.5cm Grosgrain Flesh Pink Ribbons
2.5cm Grosgrain Pink Ribbons
2.5cm Grosgrain Green Ribbons
0.3mm Tiger Wire
Iron Brooch Pin
Silver Bead Cap
White Cotton Thread
Needle
Scissors
Hot Glue

Instruction on making the pink ribbon flower brooch for girls:

Step 1: Sew a flesh pink ribbon flower

1st, cut a piece of 2.5cm flesh pink ribbon (about 10cm), and then sew it from the bottom of one end as shown in the picture;
2nd, sew the thread upwards to the fringe and then sew a half round route;
3rd, repeat the sewing patterns till you come to the end;
4th, tighten the thread and gather the ribbons to make the flower shape;
5th, snip off a short tiger wire, slide a 8mm white pearl to the middle, and then insert in in the center of the ribbon flower to make it the bud.

Step 2: Make 2 more pink ribbon flowers

1st, cut another 2 pieces of 2.5cm pink ribbons, and then sew it as you did in step 1;
2nd, tighten up the thread and make it a ribbon flower;
3rd, snip off a short piece of tiger wire, and then slide a 8mm white pearl bead to the middle;
4th, insert the wires through a silver bead cap and tighten it;
5th, attach the pearl bud to the center of the ribbon flower as pictured.

Step 3: Wrap the 3 ribbon flowers together

1st, wrap the 3 ribbon flowers together with the wires and trim off the extra wires at last;
2nd, stick a round felt paper on the back of the flowers.

Step 4: Make green ribbon leaves

1st, cut 3 pieces of 2.5cm green ribbons(about 5cm) and then cut off the fringes as shown;
2nd, roll the end and make it leaf-like as shown;
3rd, stick the other ends with the 2 sides folded;
4th, make the rest 3 leaves following the process above.

Step 5：Finish the ribbon flower brooch

1st, stick the green leaves to the back of the flowers one by one;
2nd, stick a round felt paper to the back of the green leaves again;
3rd, stick a silver brooch pin on the felt paper in the end.

Now this pink ribbon flower brooch is finished!

Are you fascinated by this pink ribbon flower brooch after reading this ribbon flower tutorial? If yes, why not have a try? A beautiful pink ribbon flower brooch with pearl bud and green leaves design is waiting for you!