Office Lady Jewelry- How to Make a Single Woven Chain Bracelet with Suede Cords

I saw a woven chain bracelet on the internet a few weeks ago, but I still remember it. Besides, it is in simple style, suit to office lady. So I can’t wait to share this DIY woven chain bracelet with you. I bet you will like this tutorial on how to make a single woven chain bracelet!

Materials needed in DIY woven chain bracelet:

3MM Suede Cord
Brass Chain
Bead Cap
0.3MM Copper Wire
Jump rings
Lobster Clasp

Instructions for DIY woven chain bracelet:

Step 1: DIY the woven chain for the bracelet

1st, cut off about 35cm brass chain, then cut about 30cm suede cord, and tie a knot onto the first circle link of the chain;
2nd, pass the sued cord up through the next circle link of chain and tighten as picture shows;
3rd, pass the sued cord down through the next circle link of chain and tighten as picture shows;

4th, repeat process 2nd and 3rd to weave the rest chain bracelet until get your desired length;
5th, cut off the extra brass chain, and then tie a knot onto the last circle link of the chain;

6th, cut off the redundant suede cords.

Step 2: Make the cord tassel for the DIY woven chain bracelet

1st, cut 5 pieces of suede cord, and overlap them together;
2nd, cut off about 25cm 0.3mm copper wire, and wrap around one end of the overlapped suede cords as picture shows;
3rd, twist the wires and slide a bead cap to the wire, cut off the extra wires and make a loop at the end.

Step 3: Finish the DIY woven chain bracelet

1st, use a jump ring to connect the suede cord tassel to the woven chain;
2nd, use a lobster clasp to connect both ends of the woven chain bracelet.

The final look of the DIY woven chain bracelet is like this:

Good job! This DIY woven chain bracelet tutorial is over! You must have known how to make a single woven chain bracelet. It is so easy for everyone, isn’t it? Just enjoy it!