How to Make a Shiny Beaded Pearl Choker Necklace for Wedding

Crystal and pearl occupy significant position in making wedding jewelry; here I'd like to share you how to make a beaded choker necklace for wedding, it is not complicated but you should be patient in DIY the choker necklace for wedding. Hope you like this wedding choker necklace

Materials on how to make a beaded choker necklace

8mm white pearl beads
3mm clear seed beads
6mm clear Czech beads
Acrylic clear drop beads
Crimp beads
Jumprings
Lobster clasp
Tiger tail 
Wire cutting plier
Flat plier

Instruction on making choker necklace for wedding

Step1: Make basic wedding choker necklace

1st, cut off a 80cm tiger tail, fold it in half, thread a crimp bead to wires, pinch the bead, thread a pearl bead to both wires, add 5 seed beads to both wires respectively, cross both wires through a pearl bead and tighten wires, continue to slide 5 seed beads to both wires respectively, cross both wires through a pearl bead, that's the basic beading pattern, repeat until you use up 16pearl beads;

2nd, add one seed bead, one Czech bead, one seed bead, one pearl bead, three seed beads, one pearl bead, one seed bead and one Czech bead to upper wire, slide one seed bead, one Czech bead, one seed bead, one pearl bead and one seed bead to lower wire, thread the below wire to the fourth seed bead on upper wire;

3rd, add one seed bead, one pearl bead, one seed bead, one Czech bead, two seed beads, one Czech bead, one seed bead, one pearl bead, one seed bead, one drop bead and one seed bead to below wire, slide the below wire back through last but one drop bead to the seventh seed bead from bottom, tighten the wire;

4th, add one seed bead, one Czech bead and one seed bead to below wire, thread the wire to the pearl bead, three seed beads and the pearl bead as the picture shows, tighten the wire, then add one seed bead to upper wire, add one seed bead, one Czech bead and one seed bead to below wire, cross both wires through a pearl bead;

Step2: Finish making choker necklace for wedding

1st, slide 5 seed beads to both wires respectively, cross both wires through a pearl bead and tighten wires, continue this beading pattern until you use up 15 pearl beads, then add 5 seed beads to both wires respectively, thread a pearl bead to both wires, at last, fasten the beads string with a crimp bead, the basic wedding choker necklace is done;

2nd, connect the necklace with a jumpring and a lobster clasp, the integrate wedding choker necklace has been finished.

The delicate choker necklace for wedding is like this:

Well done, I've finished how to make a beaded choker necklace successfully, do you like this shiny wedding choker necklace, go ahead, design your own choker necklace for wedding.