How to Make New Twist Rubber Band Bracelet by Hand

This tutorial is aimed at how to make new rubber band bracelets; the procedure is very simple, you don't need to use loom, just prepare some colorful rubber band, a rubber band tool and a rubber band hook.

Materials in making twist rubber band bracelets

Rubber bands
Rubber band tool
Rubber band hook
S clip

Instruction on how to make new rubber band bracelets

Step1: Loop a green band over the tool by twisting it to make a figure eight, then stack on two green bands; pull the left bottom band over the left top band, repeat by doing this to the right side;

Step2: Add a green band and do the same as step1, repeat until the length of the fishtail rubber bands is fit for your wrist, remove the last but one band, only leave one band on the tool;

Step3: take the fishtail rubber bands on a hook, take a transparent band and slide your hook in, pinch and pull the fishtail rubber bands to the transparent band, cross the two ends of the transparent band;

Step4: Thread the hook through the fourth layer of the fishtail rubber bands, pull the transparent band through the 4th layer, then tie a transparent band to the first transparent band, wrap a rose red band around a hook 4 times, pinch and pull the twisted band to the transparent band, then thread the transparent band to the 9th layer;

Step5: Tie a transparent band again, thread a purple twisted band to it and slide the transparent band to the 14th layer, repeat according this method, remember the space between two twisted bands are 4 layers. Stop until thread up the fishtail rubber bands;

Step6: Connect the transparent band and the green band to S clip, then connect the other end of the bracelet, the twist rubber band bracelet is done.

The final look is like this:

Ok, I've finished how to make new rubber band bracelets, do you like twist rubber band bracelets? Please join me to DIY it now!