How to Make Rainbow Rubber Band Bracelet with Acrylic Beads

There are lots of beaded rubber band bracelet designs; I will teach you make a simple but beautiful rubber band bracelet with beads; this rainbow beaded rubber band bracelet is very fit for beginners, so everyone can have a try.

Materials on how to make rubber band bracelets with beads

Rubber bands
Rubber band loom
Rubber band hook
S clip
10mm acrylic beads
Copper wire
Wire cutting plier
Flat plier

Tutorial in making beaded rubber band bracelet

Step1, prepare a 10mm acrylic bead, a rubber band and an approx 10cm 8mm-copper wire, fold the copper wire in half and pinch the wire tightly with flat plier, thread a rubber band between the wire, slide the wire to the bead, pull it out the other side but leave the band inside the bead. Slide the wire off the bead. Repeat to make other 14 bead links

Step2, loop a rubber band to pegs by twisting them to make a figure eight, add two rubber bands, pull the bottom band over the upper two bands on two sides;

Step3, add a bead link to pegs, pull the bottom band over the top band on two sides;

Step4, add a band, repeat 3rd, then add a band again, repeat 3rd, you will get the situation as top left corner of below picture shows, then add a bead link , add a band and repeat 3rd;

Step5, repeat 3rd and 4th, remember when you add a bead link and pull the bottom band over top band on two sides, then you should add band two times. Once you use up 15 beads, add a band and pull the bottom band over top band on two sides;

Step6, remove the remaining two bands. Connect the S clip onto the last loop.

The rainbow beaded rubber band bracelet is like this:

Well, the tutorial on how to make rubber band bracelets with beads is over, it is not difficult, right? If you want to learn more beaded rubber band bracelet, please stay tuned on pandahall learning center.