Kids Jewelry on How to Make Colorful Rubber Band Ring Bracelet with Loom

There are lots of rubber band bracelet designs, today I will guide you to make a rubber band ring bracelet, it is unique but very simple and you can finish it in ten minutes.

Materials in making rubber band bracelets with loom

Rubber bands
Rubber band hook
S clip
Rubber band loom

Instruction on making rubber band bracelets with loom

1st, loop two rose red rubber bands to pegs by twisting them to make a figure eight, add two green rubber bands, pull the left two rose red bands over the two green bands, do the same with the right side;

2nd, add two same color rubber bands again, repeat until the length is suitable for your wrist, take down the twisted rubber bands. Connect the S clip onto the last loop, connect the other end;

3rd, repeat 1st and 2nd until the length is suitable from your wrist to your middle finger, take down and thread it to a hook, cross the last band and tighten;

4th, repeat 1st and 2nd with same color rubber bands, stop until the length is suitable for your finger, cross the last band and tighten, connect both ends with S clip;

5th, connect the rubber band bracelet and the twisted rubber band with S clip, then connect the rubber band ring and the twisted rubber band with S clip, too.

The final look of rubber loom bracelet ring:

Ok, the tutorial on how to make rubber band bracelet with loom is over, hope you can create more rubber loom bracelet designs, thanks for your reading.