Slave Bracelet DIY - How to make a Bracelet and Ring Connected Jewelry with Chain

While browsing the internet for newly trendy jewelry, we may come across the “slave bracelet”, actually, frequently. However, this phrase does not mean to offend or abuse anybody as much as judging literally. It is a bracelet and ring connected jewelry. Keep reading and see how to make a bracelet with chains!

Supplies needed in the slave bracelet DIY

Silver Chains (thin & thick)
Jump Ring
Lobster Claw Clasp
Flat Nose Plier
Side Cutting Plier

 

How to make a bracelet and ring connected jewelry?

Step1: Prepare the chain part

1st, Cut out a short segment thin chain that will fit around your middle finger;
2nd, cut another 2 strands of thin chain for the connected branches;
3rd,wrap the thick chain around your individual wrist and cut out the segment.!

 

Step2: Assemble the bracelet

1st, open one small jump ring;
2nd, connect the starting and ending links of shortest part for wearing on your finger;
3rd, then the two similar links of the connected chains;!

 

Step3: Add clasp to finish the slave bracelet

1st, crab the thick chain and find the middle point;
2nd, now, from the middle, go out about 1cm distance on each side, attach the two ending links of connected branches to the locations you’ve found, by using the jump rings;
3rd, attach the lobster claw clasp and a larger jump ring on two ends of the bracelet.!

 

Voila! You gained yourself the bracelet and ring connected jewelry!

Try it on your hand. The slave bracelet looks wonderful over your back of hand, right? Due to it may make us a bit of indisposed feelings, I’d rather to name it a bracelet and ring connected jewelry rather than the so-called slave bracelet. Just move and act such unique jewelry for a stunning chain harness for you hand.