How to Make a Flower Cluster Necklace Pendant by Using Clay Beads and Seed Beads

This dainty flower necklace pendant is made with 5 medium-sized porcelain flowers, one large-sized polymer clay flower, several 4mm Czech glass beads and 3mm seed beads. Finally, string with a necklace making chain and you can try it on at once. Each detail of how to make this necklace pendant is recorded by the camera and showed here with essential explanation.

Supplies needed in the flower cluster pendant:

20mm Polymer Clay Flower Beads
10mm Porcelain Flower Beads
4mm Bicone Czech Glass Beads
3mm Round Seed Beads
0.3mm Tiger Tail Wire
Neckalce Making Chain
Scissors

How to start the flower cluster necklace pendant?

Step 1: Make 5 beaded loops

1st, cut a length of tiger tail wire to approximately 100cm. Then, fold it in half and slide one 4mm bicone bead to center location;
2nd, add three 3mm seed beads, one 4mm bicone bead and three 3mm seed beads onto per wire;
3rd, pass two wire ends through one 10mm porcelain clay bead;
4th, direct the flower bead down to the center of seed beads and bicone beads;
5th, pass the two ends through the seven beads added on each wire;
6th, thread the wires through one extra 4mm bicone bead from two directions;


7th, repeat the process 2~6 to make the second beaded loop;


8th, then make the third, fourth and fifth loops in same way. Attention that in the last loop, thread the two ends through the firstly added 4mm bicone bead in 1st loop.

Step 2: Add the focal 20mm polymer clay flower

1st, take the two ends towards left side; 2nd, pass them through the 20mm polymer clay flower bead together;
3rd, pass the two wires through the five beads nearby the opposite 10mm flower bead;


4th, tighten the wire ends as snugly as you can.

Step 3: Make another beaded loop

1st, add three 3mm seed beads per wire;
2nd, through the two ends through the 10mm porcelain clay bead from two directions;
3rd, add three 3mm seed beads, one 4mm bicone bead, one 3mm seed bead and three 3mm seed beads on either wire; 4th, knot two ends tightly.

Step 4: Complete the backside of flower pendant

1st, take the longer wire end and exit it at the second seed bead nearby;
2nd, add one 4mm bicone bead;
3rd, thread through the three beads at top of next bead loop;
4th, repeat the above three processes to supply one 4mm bicone bead between each two bead loops;


5th, remove the excess wire by using pliers.

Step 5: Attach the necklace making chain

Open the necklace making chain and then string the flower cluster pendant. Close the clasp then.

Done!

It's hardly to see such a feminine such a flower cluster necklace at wayside boutique or store. So, I urge all of your readers to check this tutorial and start to make your own flower pendant necklace.