Cool Ways to Make an Easy Friendship Bracelet with Chain and String in 10 Minutes

Friendship bracelets are always a typical gift to given as a token of friendship. Here, I will give an easy way to make cool and funky friendship bracelet out of chain and string. Besides, the most ingenious part in this bracelet is how I utilize the spacer bead as a terminator. Here we go.

Supplies needed in the easy friendship bracelet:

1mm Nylon Thread
Chain
4mm Spacer Bead
Jumprings
Lighter
Scissors

How to start the easy friendship bracelet?

Step 1: cut two lengths of nylon thread, about 40cm and 100cm long.

Step 2: Slide two 4mm spacer beads to the center of 40cm long piece. Fasten the two spacer beads on a flat by using a ball head pin. Then, lay the 100cm long thread over the shorter one. Pull to make two ends be equal and start to make square knots with two ends of longer thread. Stop when the length reaches 1/3 (here is 5.5cm) of your wrist circumference.


Take another two length of threads and two spacer beads, then repeat the above steps for another braid.

Step 3: Remove the pins.


Break the chain into 5cm long segments. Hold two ends of chains with two jumprings. Then, hook the thread between two spacer beads with jumpring. Close the jumpring with pliers or fingers.

Step 4: Trim off the excess working ends. Melt and seal with lighter.

Step 5: Overlap the holding ends, and make a closure by tying another 4~6 square knot with a short length of nylon thread. Finally, remove the excess cord and seal the cuts by using lighter.

Step 6: Keep 4cm at each cord end. String one spacer bead and secure with an overhand knot.

Done!

Friendship bracelets are great fun to make, and even amusing when uniting all sorts of elements like string, ribbon, chain and beads. If you’re just searching for more pictured step-by-step instructions on making easy friendship bracelet, welcome to our lc.pandahall.com!