How to Make Wrapped Friendship Bracelet with Chain and Thread in 3 Easy Steps

Everyone has been raving about the friendship bracelets. We post this easy bracelet tutorial to remind you of the old school days, and create a more excel version of varied friendship bracelets. So, when come across the memory wire, string and chain, a new design about how to make friendship bracelet just occurred strongly. Just keep reading and we’re sure you’ll love it as much as we did!

Materials needed in the easy bracelet tutorial:

Memory Wire
1mm Nylon Thread
Chain
0.5mm Brass Wire
Scissors
Lighter
Side Cutting Plier
Flat Nose Plier

How to make the friendship bracelet?

Step1: Snip 3 or more memory wire circles. Slip on your hand and stop at the widest position.

Step2: Hold the stretched circles tightly and remove them from the hand. Do not loosen the fingers.

Step3: Take the 1mm Nylon thread and tie its beginning up to the memory wire circles. Keep about 2m or more for coving the wire by thread wraps.

Step4: Start to wrap the nylon thread around the wire circles.

Step5: Once finished the wrapping, take the short length of 0.5mm brass wire to anchor the thread.

Step6: Cut off the leftover nylon thread. Then, take a 2m piece of chain, string the last link at two ends on the brass wire, fasten by several wraps and then you can start to wind the chain.

Step7: When the chain winds reaches 1/4 of entire bracelet, wind it back towards to the starting. In the end, string the chain link on brass wire and then secure by another 3 wraps.

Step8: Trim off the excess brass wire, flatten the cut with pliers.

Done! Change the colors and you’ll get another distinctive version!

Merely 3 easy steps, less than 15 minutes and you’ve finished making a new friendship bracelet. Learn how to make friendship bracelet actually doped out a good solution to the problem that what’s the most appreciate gift among girls. Nice day!