Feminine and Stylish Flower Cuff Bracelet to Make with Fabric and Lace Trim - Tutorial

This beautiful fabric flower bracelet is made of a tawny cotton fabric, white lace trim, topped with a stain ribbon strip in similar hue and three green handmade flower embellishments. Every detail is hand sewn and can provide boundless scope for our creativity. For those who had a pile of old shirts or fabric scraps at home, this fabric cuff bracelet tutorial is beneficial and favorable!

Supplies needed for the fabric cuff bracelet:

Tawny Fabric
Green Fabric
10mm Stain Ribbon
White Lace Trim
Sewing Thread
Needle
Scissors
Hot Melt Glue Gun

How to make the fabric bracelet?

Step 1: Make the ruffled fabric base

1st, cut a tawny fabric strip, about 5mm wider than the selected lace trim on both side;
2nd, make the fabric strip into a frill and then sew with the needle and thread. Or in an easier way, sew the long and short stitches alternately as picture shows, and then when pull the thread slightly you may get a ruffled fabric as well (do not cut the sewing thread).

Step 2: Add on the lace trim and stain ribbon

1st, get a long piece stain ribbon;
2nd, lay the lace and ribbon over the center of ruffled fabric cuff;
3rd, take the needle and sew the three parts together, knot securely and trim the excess thread.

Step 3: Adorn the flower embellishments

1st, cut a 2cm wide green fabric strip;
2nd, fold the start and roll inwards with your finger;
3rd, keep folding and rolling the fabric until the flower reaches the size you want; 4th, sew to keep the flower in shape;



5th, sew it onto the cuff bracelet; 6th, repeat the processes above for another two flower embellishments.

Tie the ribbon ends into a bow and done!

There you’ve made your fabric cuff bracelet! It would be a pretty accessory for an evening dress, and when you try adding some elegant pearls or rhinestone cabochons, it would also make a wonderful wedding accessory or a bridesmaid gift.